How to Increase Partition in Linux using LVM ?

Resize of LVM partition is very easy in Unix , resize of LVM partition can be done without unmounting the the existing file system parition.

let’s assume that you have an ext3 partition lv_root which is mounted on / and a swap partition lv_root in a logical volume group vg_controller, now you are running out of space in /, there’s no space left in the above volume group but you have a brand new disk drive with lots of free space. How to add some space to the / partition?

WARNING: If you have important data in any directory under / then backup before attempting this.

Steps to increase or re-size the existing Linux partition using LVM ?

I’ll assume the spare disk is called /dev/sdb(108GB), make sure to switch to administrator (root)

[root@experts ~]# df -h

Filesystem            Size  Used Avail Use% Mounted on


50G  4.0G   43G   9% /

tmpfs                 2.9G  224K  2.9G   1% /dev/shm

/dev/sda1             485M   56M  404M  13% /boot


245G  188M  233G   1% /home


know physical volumes..

[root@compute1 ~]# pvdisplay

know volume groups

[root@experts ~]# vgdisplay

know Logical Volume created and mapping

[root@experts ~]# lvdisplay

check disk attached status

 [root@experts ~]#fdisk -l

Disk /dev/sdb: 108.4 GB, 108447924224 bytes

255 heads, 63 sectors/track, 13184 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

Sector size (logical/physical): 512 bytes / 512 bytes

I/O size (minimum/optimal): 512 bytes / 512 bytes

Disk identifier: 0x00000000

know Volume Group created

2. Create a new partition of appropriate size using fdisk and also change partition id.

[root@experts ~]#fdisk /dev/sdb


Create an ext3 file system in the partition this is required to make file system usable .

[root@experts ~]#mkfs.ext3 /dev/sdb2


Initialize the partition for use as a physical volume in lvm and add it to vg_controller

[root@experts ~]#pvcreate /dev/sdb2

 [root@experts ~]#vgextend vg_controller /dev/sdb2


Extend lv_root (use ‘df -h’ to check that / is mounted on lv_root) as required (by 90G here)

# lvextend -L +90G /dev/vg_controller/lv_root


Finally, resize the filesystem (this part normally would require unmounting /, but for ext3 and 2.6 Kernels it works while the partition is mounted)

[root@experts ~]#resize2fs /dev/vg_controller/lv_root

Watch out below video

Leave a Reply

Your email address will not be published. Required fields are marked *

+ 56 = 57